3 To 4 Blade ?
#2
Platinum Member
Platinum Member
I just did that on my Cafe I had 2 sets of 3 blades Mirage 23P and would hit 5050 (rev limiter from what I read) with 2000 502 Mag MPI's and 2000 Bravo One's, speed was 64.8 MPH GPS.
Tried 4 blade labed Spinelli's 24P from "cowlis" and hit 67.4MPH GPS still reved 5000. Bought them from him then and there! I concluded it was underproped, and BTW I am no expert, this is just my experience.
Boat 1994 Cigarette 35' Cafe Racer 10,000# no mods.
I noticed that the drives seem to run hotter (more oil in drive oil expansion tank) but I have received my fathers day present in the for of Simrek Drive showers that I will install tomorrow. I can keep you posted if you care Sling.
Tried 4 blade labed Spinelli's 24P from "cowlis" and hit 67.4MPH GPS still reved 5000. Bought them from him then and there! I concluded it was underproped, and BTW I am no expert, this is just my experience.
Boat 1994 Cigarette 35' Cafe Racer 10,000# no mods.
I noticed that the drives seem to run hotter (more oil in drive oil expansion tank) but I have received my fathers day present in the for of Simrek Drive showers that I will install tomorrow. I can keep you posted if you care Sling.
Last edited by GLH; 05-29-2003 at 09:29 PM.
#6
Registered
sling,
need to go down. get a 22 pitch four blade.
anytime you are adding blades you have to go down in pitch not up. if you had a 24 four blade and were going to a five you would use a 23 or 22 depending on the boat.
Treadwell
need to go down. get a 22 pitch four blade.
anytime you are adding blades you have to go down in pitch not up. if you had a 24 four blade and were going to a five you would use a 23 or 22 depending on the boat.
Treadwell
#8
Platinum Member
Platinum Member
Sling,
Is this for your 25 Outlaw? I've got the same boat with 496HO.
Max horsepower on that engine is at 5000.
A labbed 24 B1 is ideal for most of your running around. It planes great with all loads and runs well in the mid-range. Little too much stern lift for max speed, however.
For max speed, I've found a labbed 25 Mirage works best. It really picks the boat out of the water. I have one that was cut down in diameter slightly and labbed with additional cupping and it runs great. Not the best planer, though.
Is this for your 25 Outlaw? I've got the same boat with 496HO.
Max horsepower on that engine is at 5000.
A labbed 24 B1 is ideal for most of your running around. It planes great with all loads and runs well in the mid-range. Little too much stern lift for max speed, however.
For max speed, I've found a labbed 25 Mirage works best. It really picks the boat out of the water. I have one that was cut down in diameter slightly and labbed with additional cupping and it runs great. Not the best planer, though.
#10
Platinum Member
Platinum Member
FYI, Mine came equipped with a 23P Mirage Plus also...I've been running the 25 described above for a while now. It planes like the stock 23 did, lowered my mid-range rpms and improved my top end.
But I would still prefer a 4-blade for when I have a fully-loaded boat. One thing at a time, though.....
But I would still prefer a 4-blade for when I have a fully-loaded boat. One thing at a time, though.....