aftermarket exhaust manifolds [price]
#1
Registered
Thread Starter
Join Date: Apr 2001
Location: beaumont tx
Posts: 1,703
Likes: 0
Received 0 Likes
on
0 Posts
aftermarket exhaust manifolds [price]
Well I am wanting to upgrade my exhaust this winter, any OSO advertiser's running a sell on some aftermarket manifolds to fit a pair of 454 mag mpi's with cap. call? if so how about some info on who has the deals going on!!!! thanks, also what is the best bang for your buck on manifolds
Mark R
Mark R
#2
Charter Member #927
Charter Member
#4
Registered
Thread Starter
Join Date: Apr 2001
Location: beaumont tx
Posts: 1,703
Likes: 0
Received 0 Likes
on
0 Posts
thanks for the link, I am also looking at Gill and Imco, I heard that imco runs the water through the flange instead of a hose bypass will this cause problems
#7
Registered
H2Xmark,
I have a set of IMCO Powerflow's with the short risers for captains call, all the brackets, hoses, belts, etc. to install on a Gen V engine.
If interested lets talk.
Mark
I have a set of IMCO Powerflow's with the short risers for captains call, all the brackets, hoses, belts, etc. to install on a Gen V engine.
If interested lets talk.
Mark
#8
Banned
Join Date: Sep 2001
Location: Deland, Florida
Posts: 25,191
Likes: 0
Received 0 Likes
on
0 Posts
I bought a set from Dennis Moore, they were quite a bit less than Merc manifolds and are supposed to flow better. I still don't have the engine together yet, so I can't give an opinion on the performance. They were cost effective enough that I had them shipped from Cali and still saved quite a bit.
#9
Performance Boat Center
VIP Member
I just did Stainless Marine exhausts. The engines really run much stronger.
I actually lost speed on top because I can't keep 'em off the rev limiters. I have some new props to test next week.
The SMs sure were'nt cheap....
And... I have a leak on one of them somewhere... I can't find it too easy. I tried while the engine was at 3000 on the hose, but no evdence...
I know I have a leak because the water dries and leaves salt behind...
I actually lost speed on top because I can't keep 'em off the rev limiters. I have some new props to test next week.
The SMs sure were'nt cheap....
And... I have a leak on one of them somewhere... I can't find it too easy. I tried while the engine was at 3000 on the hose, but no evdence...
I know I have a leak because the water dries and leaves salt behind...
__________________
Tim Gallagher
Performance Boat Center-FL
[email protected]
954-809-8739
Wright Performance, MTI, Cigarette, Sunsation
Tim Gallagher
Performance Boat Center-FL
[email protected]
954-809-8739
Wright Performance, MTI, Cigarette, Sunsation