28 Skater Repower--- 2.5 race to 300x's
#91
Registered
Re: 28 Skater Repower--- 2.5 race to 300x's
i'm spinning 15x32's at 63-6400 and my best is 106. according to spectre i can bring my motors up approx 1/2 inch more if i wanted more out of her. water pressure is fine right now...16-20 at 100+ mph. that 106 was also with 2 people and apprx 90-100 gals of fuel...but its a consistent 100-102 boat reguardless of load
#94
Registered
Re: 28 Skater Repower--- 2.5 race to 300x's
according to spectre he usually sets them at 1 5/8's above...says with right prob, right set-up...yada yada he's seen plenty run in the low 1 teens
#95
Registered
Re: 28 Skater Repower--- 2.5 race to 300x's
Originally Posted by mmwalters
Yea us poor boys are stuck with those old fishing boat motors. I did have the rev limiters reset by repair as they kicked in at 6100rpm. But with the 34s I never see over 6400rpm.
With the 15x34s are you hitting the rev limit ?
With the 15x34s are you hitting the rev limit ?
#96
Registered
Re: 28 Skater Repower--- 2.5 race to 300x's
Originally Posted by berns29scarab
according to spectre he usually sets them at 1 5/8's above...says with right prob, right set-up...yada yada he's seen plenty run in the low 1 teens
#97
Registered
Join Date: Dec 2002
Location: chesapeake bay md
Posts: 959
Likes: 0
Received 0 Likes
on
0 Posts
Re: 28 Skater Repower--- 2.5 race to 300x's
Bern Your motor height is very conservative, 1 3/4''- 2'' would be close to max. I think you have some speed hiding your setup yet.
Wayne My boat ran 109 at 6100 as well, interesting. Most of the ecu boxes seem to kick the limiters at 6400rpm. mine for some reason were at 6100rpm. TheY are now at 6700rpm
Did you say 109.2???????
Wayne My boat ran 109 at 6100 as well, interesting. Most of the ecu boxes seem to kick the limiters at 6400rpm. mine for some reason were at 6100rpm. TheY are now at 6700rpm
Did you say 109.2???????
Last edited by mmwalters; 10-20-2005 at 12:11 PM.
#100
Registered
Join Date: Dec 2002
Location: chesapeake bay md
Posts: 959
Likes: 0
Received 0 Likes
on
0 Posts
Re: 28 Skater Repower--- 2.5 race to 300x's
Originally Posted by berns29scarab
peak rpm's for the x's are 65-6800...according to the manual the limiters are set at 7100
Those old promaxs were designed for old fishing boats or crab boats!