Center Tab Gone?????? Where to replace fast?
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Apr 2001
Location: Saratoga Springs, N.Y.
Posts: 2,910
Likes: 0
Received 0 Likes
on
0 Posts
Center Tab Gone?????? Where to replace fast?
During the poker run this weekend I tore the center tab off the boat. The only part I lost. was the tab and the piece where the tab mounts. I also need to replace the piston that controls it. Looks like a pretty easy repair, any advice where to get the parts and anything I need to know about re-installation? thanks
#2
Charter Member#157
Charter Member
Join Date: Oct 2000
Location: Minneapolis, Mn, Usa
Posts: 1,859
Likes: 0
Received 3 Likes
on
3 Posts
Re: Center Tab Gone?????? Where to replace fast?
what type of tab?
Manufacturer?
Mine is a custom made unit so it would really suck to loose it
I am curious what you had since I am looking into redoing mine.
Been looking at the Keakafer one. I think a 280 or 380.But also like the one that Trick Marine (Too Old) sells
Manufacturer?
Mine is a custom made unit so it would really suck to loose it
I am curious what you had since I am looking into redoing mine.
Been looking at the Keakafer one. I think a 280 or 380.But also like the one that Trick Marine (Too Old) sells
__________________
This Cat is trying to keep up with the Big Dogs
This Cat is trying to keep up with the Big Dogs
#3
Charter Member#157
Charter Member
Join Date: Oct 2000
Location: Minneapolis, Mn, Usa
Posts: 1,859
Likes: 0
Received 3 Likes
on
3 Posts
Re: Center Tab Gone?????? Where to replace fast?
Fred, the seond pic, the blue tab
what are the deminsions on this?
And also how far is the total stroke?
This is the one I am thinking about to replace my current one.
However I would have to mount on the transom versus under the notch that it currently is. But the current setup is too weak. I keep bending the hinge.
Thanks
what are the deminsions on this?
And also how far is the total stroke?
This is the one I am thinking about to replace my current one.
However I would have to mount on the transom versus under the notch that it currently is. But the current setup is too weak. I keep bending the hinge.
Thanks
__________________
This Cat is trying to keep up with the Big Dogs
This Cat is trying to keep up with the Big Dogs
Thread
Thread Starter
Forum
Replies
Last Post
Harper220
General Boating Discussion
19
12-07-2005 10:47 AM