Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)
-   -   Anyone have one of these laying around?? Need one. (https://www.offshoreonly.com/forums/general-boating-discussion/89384-anyone-have-one-these-laying-around-need-one.html)

Waterfoul 10-26-2004 08:21 PM

Anyone have one of these laying around?? Need one.
 
1 Attachment(s)
Oil pressure sender. It's a VDO... Made in Germany That's all it says on it. I broke off the screw that the wire attaches to. I"ve tried several other senders and they all send my gauge in different directions.

'Foul

eMotiondriver 10-26-2004 08:43 PM

Re: Anyone have one of these laying around?? Need one.
 
Go to an import car part aftermarket place should be no problem. Seen them on older VW's 70-80's Triumphs, MG, Merceedes etc....

Good luck

eMotiondriver 10-26-2004 08:45 PM

Re: Anyone have one of these laying around?? Need one.
 
Or even the small garage that works on the above.

Volvo, Saab also...

Waterfoul 10-26-2004 08:56 PM

Re: Anyone have one of these laying around?? Need one.
 
I've tried just about every marine supply place around here. Never thought about auto parts shops.

mcollinstn 10-26-2004 09:10 PM

Re: Anyone have one of these laying around?? Need one.
 
and VDO senders use the same calibrations as another brand.
Can'tremember which one though..

It'll come to me in the middle of the night (I keep a notepad on the nighttable).

eMotiondriver 10-26-2004 09:25 PM

Re: Anyone have one of these laying around?? Need one.
 

Originally Posted by mcollinstn
and VDO senders use the same calibrations as another brand.
Can'tremember which one though..

It'll come to me in the middle of the night (I keep a notepad on the nighttable).


LMFAO

puder 10-26-2004 09:37 PM

Re: Anyone have one of these laying around?? Need one.
 
BMWs use them as well. Make sureits the right pressure range for your guage. I use them on my race car and for the longest time I though i had low oil psi. Turns out they sent me a 0-5 bar instead of a 0-10 so all my reading were half of what they actualy were.

Waterfoul 10-26-2004 09:40 PM

Re: Anyone have one of these laying around?? Need one.
 
Ah Ha! It says 0-10 bar on the steel fitting! And on the opposite side of the same fitting it says 1.93 I never even looked at the fitting.

Thanks puder!

Keith 10-27-2004 06:36 AM

Re: Anyone have one of these laying around?? Need one.
 
You can also try www.egauges.com for VDO stuff, I purchased some replacement gauges from them last year.

cuda 10-27-2004 06:50 AM

Re: Anyone have one of these laying around?? Need one.
 
I bought one at Napa. They were proud of it. :(


All times are GMT -5. The time now is 01:53 PM.


Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.