TerminalVelocity

Just purchased a Warlock Offshore 29 (used) but it did not come with the acrylic wind deflectors. Does anyone know where I can purchase them?

Harper220

I've had Finney's in Arizona do several for me. I've got them on my 28 Daytona. They can make custom sizes if you give them the measurements. They also powdercoat the rails and offer a screen that has a lip, which I highly recommended. Great quality!

Hope this helps...

www.finneys.com

TerminalVelocity

Thanks for the recommendation. I'll look them up. Appreciate the help.

TerminalVelocity

Thanks for the reply. Acrylic is not necessary. Just need to be able to withstain 80-90 mph speeds. Will they? Do you have any rail clamps to hold them in place? What other colors are available?

My email address is [email protected]

DanB

I had finneys do a new set for my warlock and they turned crappy after a couple of years. (cracked at the holes) Take your old ones to any plexi place in your area and they can make them..... much cheaper too. The brackets from Finneys work good tho.

Harper220

I've had mine for three seasons and haven't had any problems with cracking anywhere...
I even move them up and down on the rail all the time. I depends on how much you tighten them and how you treat them. Tights, tight, too tights broke.

I don't have any spare clamps. That would be a low cost item from Finney's.

TV- I have a two foot wide shield complete that I never installed between the driver and passenger side shields. More than likely I won't install it since that area gets crawled over so much to get on the deck.

If this would be of any use to you, I would sell it.

TerminalVelocity

Harper - Thanks for the feedback. I'll give finneys a try first and see how that cuts the wind at speeds. Thanks again.

TerminalVelocity

Thanks DanB for the recommendation.