transom thickness
05-01-2005, 01:41 PM
#1
Charter Member #737
Charter MemberThread Starter
transom thickness
Does anyone know how thick a transom is suppose to be?
Gold Member
Re: transom thickness
Platinum Member
05-01-2005, 02:38 PM
#5
Charter Member #737
Charter MemberThread Starter
Re: transom thickness
Originally Posted by hillbilly24
2-1/4 inch I believe
05-01-2005, 03:52 PM
#6
Re: transom thickness
My SSMIII service manual requires transom thickness to be a minimum of 2" and a maximum of 2 1/4".
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
05-01-2005, 05:27 PM
#7
Registered
Join Date: Oct 2000
Location: Wilmington,De,USA
Posts: 813
Likes: 0
Received 0 Likes
on
0 Posts
Re: transom thickness
Originally Posted by tcelano
My SSMIII service manual requires transom thickness to be a minimum of 2" and a maximum of 2 1/4".
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
Re: transom thickness
05-02-2005, 08:59 AM
#10
Charter Member #737
Charter MemberThread Starter
Re: transom thickness
Thanks for the info. Mine was only an 1 7/8" and the top to bottom surface was not to parallel.
Originally Posted by tcelano
My SSMIII service manual requires transom thickness to be a minimum of 2" and a maximum of 2 1/4".
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
The surfaces must be parallel within 1/8" measured top to bottom of the cutout hole.
The inside surface must be flat to within 1/8"
The outside surface must be flat to within 1/16"
Transom angle 13 to 16 degrees.
I assume other drives will have similar design requirements.
