motor heighr on Scarab
#1
Registered
Thread Starter
motor heighr on Scarab
boat is a 30" Scarab center console, chine walks at 60MPH , i think my motors are way to deep (9 1/2" from the hull to the nose) motors are 94 Johnson 250HP V8s, boat runs at about 6000-6500 lbs,
Another weird thing is no bracket on my boat, most of these boats had a bracket, maybe the V8s were so heavy they mounted them direct to the stern back then (wellcraft couldn't tell me why) any insight ??
Another weird thing is no bracket on my boat, most of these boats had a bracket, maybe the V8s were so heavy they mounted them direct to the stern back then (wellcraft couldn't tell me why) any insight ??
#3
Registered
Join Date: Jan 2001
Location: ST. Louis, MO, USA
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
Re: motor heighr on Scarab
I've never seen a boat NOT perform better with a bracket. Why not buy a couple of adjustable setback/brackets. The manual ones are inexpensive and you can get the boat set up as you like it in an afternoon.
#4
Registered
Thread Starter
Re: motor heighr on Scarab
thats kind of what I'm thinking Gary, was wondering if my setup was as far off as i think it is thou, does seem real deep correct?
#5
Registered
Join Date: Jan 2001
Location: ST. Louis, MO, USA
Posts: 1,658
Likes: 0
Received 0 Likes
on
0 Posts
Re: motor heighr on Scarab
Not sure if it's too deep, never measured one. But most manufactureres will set up boats conservatively, just in case to want more trim control with the 6 kids, 4 coolers, etc in the bow.
Get the manual jack plates, you'll be happy.
Gary
Get the manual jack plates, you'll be happy.
Gary
Thread
Thread Starter
Forum
Replies
Last Post
jody165
Scarab
3
08-31-2005 12:32 PM
terrygar
General Boating Discussion
4
08-08-2005 05:11 PM