Mercury/Quicksilver Spanner Wrench... B1 Trim Cylinder End Cap Removal
#1
Mercury/Quicksilver Spanner Wrench... B1 Trim Cylinder End Cap Removal
Tool needed to remove the end cap of a B1 Trim Cylinder:
Merc P/N : 91-821709
I don't have any spanner wrenches; never even used one. Can this be picked up as a Craftsman or Snap-On part?
Thanks!
Merc P/N : 91-821709
I don't have any spanner wrenches; never even used one. Can this be picked up as a Craftsman or Snap-On part?
Thanks!
#2
Re: Mercury/Quicksilver Spanner Wrench... B1 Trim Cylinder End Cap Removal
Brian, nothing special about spanner wrenches. Pick up an adjustable one over a fixed one. Just make sure the pin dia's are not to big for what you need. There are different sizes. I don't know what size you need off hand.
http://www.sears.com/sr/javasr/produ...table+Wrenches
You can make a cheap and dirty one using bolts for the pins.
http://www.sears.com/sr/javasr/produ...table+Wrenches
You can make a cheap and dirty one using bolts for the pins.
Last edited by US1 Fountain; 09-29-2005 at 05:25 PM.
Thread
Thread Starter
Forum
Replies
Last Post
Sydwayz
General Boating Discussion
3
09-30-2005 11:58 AM
Dusty Times
General Boating Discussion
6
03-19-2004 08:12 AM