Need Bell Housing Pics
#1
Registered
Thread Starter
Need Bell Housing Pics
Does anyone have a B1 bell housing off they can take some pics of. I need to see how the Oil Resevoir is plumbed from the inside of the Bell housing, through the gimbal housing and into the boat. I added an HP bell housing to an 89 B1 setup last year and now I need to finish plubming it for the Oil resevoir, so I can bolt an XR on it.
Thanks
Thanks
#2
Platinum Member
Platinum Member
Join Date: Sep 2005
Location: Ste Genevieve, MO
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need Bell Housing Pics
My 93 B1 bell housing is currently sitting in my house and can take some pics.
Its a brass hose barb on the backside to the resevior hose which goes to another hose barb on the gimbal housing.
I will try to take pics tonight and post.
Its a brass hose barb on the backside to the resevior hose which goes to another hose barb on the gimbal housing.
I will try to take pics tonight and post.
#4
Platinum Member
Platinum Member
Join Date: Sep 2005
Location: Ste Genevieve, MO
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
Re: Need Bell Housing Pics
For now I can only give you a pic of #8. The boat is stored about an hour away from my house and would not get to the others until Sat.
Last edited by Advantage 27; 07-07-2011 at 08:21 PM.
#5
Registered
Thread Starter
Re: Need Bell Housing Pics
Advantage27 - Thanks - great pic. Looking forword to anymore you can get this weekend. Hey - worse case it's a good reason to check on the boat. I probably already know the answer to this, but does the motor have to come out to get to these fittings.