HELP!!! Pressure Checking Gil Mainifold???
07-02-2006, 10:22 PM
#12
Registered
Thread Starter
Join Date: Mar 2006
Location: Montgomery, TX
Posts: 891
Likes: 0
Received 0 Likes
on
0 Posts
Re: HELP!!! Pressure Checking Gil Mainifold???
Ok I pressured up the manifolds, one held constant the other however did not even hold any. I will pull it to inspect tommorrow. Do you think that I should replace both manifolds or all four And if so what would you recomend?
07-03-2006, 06:18 AM
#13
Charter Member #927
Charter Member
Re: HELP!!! Pressure Checking Gil Mainifold???
Most recomend replacment. If you run in Salt it is only a matter of time.
I had a leak right at the top of the devider between runners. I had mine TIG welded 2 years ago. and it is fine. My manifolds had run in salt, I run in fresh.
I had a leak right at the top of the devider between runners. I had mine TIG welded 2 years ago. and it is fine. My manifolds had run in salt, I run in fresh.
07-03-2006, 06:03 PM
#15
Charter Member #927
Charter Member
Re: HELP!!! Pressure Checking Gil Mainifold???
I'm not sure on the age. They were used when I bought them. At 10 years old I would think they need checked very carefully or replaced.
