CONTURA III switch covers

always wanted · 03-20-2007, 09:18 AM

I am looking for 6 white switch covers, with black lettering to replace my trim panal switches on a 33 OUTLAW. They have worn off and I just bought the boat over the winter and am starting to clean up some little things. I am looking for switches labeled BOTH (I think..cant read it so worn), PORT, STRB, TRAILER, TRIM and TRIM.

I was able to find blank switches but not ones that are labeled. All the new ones are black with white letters. Dont want to replace all of them. Any assistance would be appreciated.

Thanks,
Brian

FunHome · 06-24-2008, 11:23 PM

I have a friend that is looking to do the same..... Did you ever find them??

Kims · 06-25-2008, 04:23 PM

I have looked for those for a very long time. I am trying to get the ones where the letters are lit up at night... Contacted the manufacturer who said I had to order 50 of each to get the lettering. Surprize that Livorsi or someone has not jumped on this and started selling them labeled...

Chris Sunkin · 06-25-2008, 04:42 PM

These people stock a fairly broad selection of off-the-shelf labelled switch covers for marine use-

http://www.mastervolt.com/products.p...23&prg_id=1130

Kims · 06-25-2008, 06:10 PM

Quote:

Originally Posted by Chris Sunkin

These people stock a fairly broad selection of off-the-shelf labelled switch covers for marine use-

http://www.mastervolt.com/products.p...23&prg_id=1130

Close but no cigar... they are black. They are also produced in white but I guess Wellcraft and Cig are the only ones ordering enough to have the correct labels. I like letters rather than symbols and I know it is just a matter of time before genuinedealz on ebay or someone else stocks them..

minxguy · 06-25-2008, 07:36 PM

Try Ultra Panel Marine in Miami 305-888-7709.

Ken

Chris Sunkin · 06-25-2008, 07:49 PM

There's a switch manufacturer out there that makes blanks and they're engraveable with standard equipment. I've searched my links and my files to no avail- sorry. If I happen across them I'll let you know.

Kims · 06-26-2008, 12:08 AM

Quote:

Originally Posted by Chris Sunkin

There's a switch manufacturer out there that makes blanks and they're engraveable with standard equipment. I've searched my links and my files to no avail- sorry. If I happen across them I'll let you know.

That will be appreciated. I contacted the manufacturer and despite being very helpful, they could not lead me into anyone that had them in stock.