axapowell

Anybody have a part number for MSD 8.5mm wires that fit a HP500 Carbed motor? I will build them if I have to, but I am looking for a pre-made set. Running the stock Merc distributor and need 90* boots at both ends.

Thanks,
Dave

mrhorsepower1

I can order them for you I am a WD for MSD.

rchevelle71

iTrader: (1)

Would these be the same as a 454 330?? I will also need a set.

C_Spray

iTrader: (2)

I just went through this, and wound up buying Taylor 8.2mm Thundervolt wires - $69.99 at Summit TAY-83253. They are available in blue and black, too. I did have to put the distributor ends on, but that was by choice - I wanted them to fit exactly right. Most of the wires were pretty close right out of the box, but everyone routes them just a little different. Fortunately, I had access to the special strippers/crimpers needed.

KEPP

The part number you are looking for is a #120-31489 8.5MM wire set. We have loads of them on the shelf and they are only $83.99. Our phone number is 386-446-0660 or feel free to shop securely at our website here the product link http://www.keitheickert.com/detail.aspx?ID=477

RaggedEdge

Call me, I've got new wires i bought for the 500's that I never used, and thinking I never will with the 525's. You've got the number.

axapowell

Thanks everyone...

Dave

offthefront

iTrader: (1)

I just installed 2 sets of MSD 8.5's and they are nice wires cept I was dissappointed in the length's ... I might have ordered the wrong ones but as close I could see was BBC "under headers" They worked but I had to use my "plug wire stretcher" to get some to reach ...m