Alarm on 496HO'S
#1
Registered
Thread Starter
Join Date: Apr 2003
Location: Lake George, NY
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
Alarm on 496HO'S
Ok,
So I put the boat in Sat.
Started it and get an alrm about every 3 to 4 minutes. All gauges show good. All fluids are new and show good on sticks. Outdrive bottles full. New water seperators, new impellors, motors only have 51 hours.
Took it out and if I get on it the alarm goes on steady until I back off then only goes on every 3 minutes for a couple of seconds. All gauges show good even when I'm on it.
Any sugestions?
Bret
So I put the boat in Sat.
Started it and get an alrm about every 3 to 4 minutes. All gauges show good. All fluids are new and show good on sticks. Outdrive bottles full. New water seperators, new impellors, motors only have 51 hours.
Took it out and if I get on it the alarm goes on steady until I back off then only goes on every 3 minutes for a couple of seconds. All gauges show good even when I'm on it.
Any sugestions?
Bret
#4
Registered
Thread Starter
Join Date: Apr 2003
Location: Lake George, NY
Posts: 348
Likes: 0
Received 0 Likes
on
0 Posts
#5
Registered
A soft alarm that turns into a hard alarm (but doesn't show on the gauge) is most likely an exhaust manifold overtemp. If you have an infrared temp gun you should check manifold and elbow temps.
#7
Registered
Not a hole anymore...all backfilled and radiant tubing and bath plumbing being installed this week. Floors poured by monday and framing by wednesday of next week. Im catching you quick !!!!