riser length for cam
01-03-2009, 11:01 AM
#1
Registered
Thread Starter
Join Date: Jul 2007
Location: lorain,ohio
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
riser length for cam
hi guys , just a quick question ? would standard length risers on stainless marine manifolds work with cam of .224/[email protected]" ? i'm getting away with it now with merc center risers/standard risers. yes this is a small block. wondering if increased flow of manifold might be an issue. thanks
01-03-2009, 11:27 AM
#2
Registered
Join Date: Jul 2007
Location: Lake Winnebago, MO, 43MM LOTO
Posts: 220
Likes: 0
Received 0 Likes
on
0 Posts
Whats the engine? I put SM standard risers on my mx 6.2 cause I wanted to keep the Q&Q and was told my set up was right on the edge, I've run them for 40+ hrs. with no problems, if your indoubt call Brownie @ SM. Goodluck Steve
Last edited by osur866; 01-03-2009 at 11:34 AM.
