oil pressure gages
#1
Platinum Member
Platinum Member
Thread Starter
iTrader: (5)
Join Date: May 2001
Location: NO WHERE
Posts: 3,358
Likes: 0
Received 0 Likes
on
0 Posts
oil pressure gages
i have a new livorci oil pressure gage . the needle wont move if i pull the sender wire and run a wire to the sending unit it pegs? put a new sending unit in and it does the same what am i doing wrong?
#6
Platinum Member
Platinum Member
Thread Starter
iTrader: (5)
Join Date: May 2001
Location: NO WHERE
Posts: 3,358
Likes: 0
Received 0 Likes
on
0 Posts
whats it mean when the gage pegs, i tried a diff gage and it did the same thing, i bought new gages and am using a oriellys sender should i buy one from livorci .
Last edited by johnnyboatman; 05-21-2009 at 10:14 PM.
#7
Registered
Join Date: Mar 2009
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
Normaly if the gauge is peged to max then something is grounded out and that could be at the gauge it self, Could be the wire from the sender to the gauge. look on the gauge it self some times the post for the ground will have ground signs with the 3 lines over each other ---
#10
Platinum Member
Platinum Member
Thread Starter
iTrader: (5)
Join Date: May 2001
Location: NO WHERE
Posts: 3,358
Likes: 0
Received 0 Likes
on
0 Posts
Gage Is Good, Ran Sender From Good Side To Bad Side And Gage Works Fine. If I Touch The Sender With A Test Lite It Shows To Be Grounding Out . Even If I Touch The Spade Part Of The Sender