Imco or emi?
#2
Registered
OK, both are a great choice. I looked at the Imco and looked like very good quality. I went with the EMI with long risers. That was 5 years ago so I cannot tell you why I chose one over the other.
#3
Registered
IF I were you id do some more reading on EMI. (taking the high road)
I have LOTS of experience with Imco and they've been awesome.
I think the powerflow pluses definitely have a longer runner.
Boostpower and Teague use Imco as well.
Take a look at lightning - they have a very high quality header for less $ than CMI.
UD
#4
Registered
Thread Starter
Join Date: May 2009
Posts: 204
Likes: 0
Received 0 Likes
on
0 Posts
imco has the thunder power as well, whats the difference between this and the powerflow? The lightnings still look to be over 2k an engine unless im missing something. Thanks again
#7
Registered
IF I were you id do some more reading on EMI. (taking the high road)
I have LOTS of experience with Imco and they've been awesome.
I think the powerflow pluses definitely have a longer runner.
Boostpower and Teague use Imco as well.
Take a look at lightning - they have a very high quality header for less $ than CMI.
UD
I have LOTS of experience with Imco and they've been awesome.
I think the powerflow pluses definitely have a longer runner.
Boostpower and Teague use Imco as well.
Take a look at lightning - they have a very high quality header for less $ than CMI.
UD
#8
Registered
Take a look at what Eddie Young has to say about his experience selling and building engines with EMI's.
You'll find it just search for - EMI problems.
I prefer not to speak for Eddie, and I respect him as do may here on OSO.
I don't know of a single high end builder that uses EMI.
I personally have no experience with EMI.
I have a lot of personal experience with Imco.
I have Imcos on my 406 SB tunnel hull
My Ilmor 710 has Cmi's
Uncle Dave
#10
Registered
The powerflow has higher risers bigger ID and a better runner on the inside of the manifold - I have these.
The powerflow plus has the most sophisticated riser of the group with primary tubes running the entire length of the riser. the exhaust is rectangle shaped giving side by side installs more clearance. - its an excellent manifold
UD