In a bind with Trailer Trim
Getting ready for the weekend and went to trim the drive up and nothing using the trailer trim.
Motor trim works fine. But trailer trim nothing? I had moved the pump of to the side to fefinsh the floor yesterday and it di tip on its side for a moment. However after reinstallation I trimed it down to install a drive shower and now it will not trailer trim, only the running trim. |
Is the solenoid clicking? Did it leak Fluid?
If the solenoid is not working, clean wire connections and retry. If this still does not work, and you cant find a replacement right away you can jump it with a screwdriver or wire jumper like a starter solenoid. |
check the plug for the wiring mine did the same thing a while back unplugged it and plugged it back in no problems since
|
Ok Dumb A$$ here with a new boat.
After pulling the switch panel and using my test light I found the purple from trim was power out for up and has a jumper to the trailer switch. So I say to self how could it have power to the trailer if I don't have the other switch activated......ya hold both down...:lolhit: First boat that the trim was not on the handle (dual controld) so guess that is a safety so you don't activate the trailer trim runnig. |
Trim limit switch stops it then you have to push both switches.
|
i didnt even think about you not pushing both buttons together LOL
|
All times are GMT -5. The time now is 01:25 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.