In a bind with Trailer Trim

[aven2rus]

Getting ready for the weekend and went to trim the drive up and nothing using the trailer trim.

Motor trim works fine. But trailer trim nothing?

I had moved the pump of to the side to fefinsh the floor yesterday and it di tip on its side for a moment.

However after reinstallation I trimed it down to install a drive shower and now it will not trailer trim, only the running trim.

[rchevelle71]

Is the solenoid clicking? Did it leak Fluid?

If the solenoid is not working, clean wire connections and retry. If this still does not work, and you cant find a replacement right away you can jump it with a screwdriver or wire jumper like a starter solenoid.

[Ebay Ed]

check the plug for the wiring mine did the same thing a while back unplugged it and plugged it back in no problems since

[aven2rus]

Ok Dumb A$$ here with a new boat.

After pulling the switch panel and using my test light I found the purple from trim was power out for up and has a jumper to the trailer switch.

So I say to self how could it have power to the trailer if I don't have the other switch activated......ya hold both down...

First boat that the trim was not on the handle (dual controld) so guess that is a safety so you don't activate the trailer trim runnig.

[Irishtornado]

Trim limit switch stops it then you have to push both switches.

[Ebay Ed]

i didnt even think about you not pushing both buttons together LOL