Sick Stinger

iTrader: (23)

Quick question
1. I need filetr head to block mouting gaskets. One is an O Ring the other is a paper gasket. Any idea where I can get them?
2. I have Merc/Gil Mani's and risers. They have a steel cone shaped gasket with 2 flat gaskets on either side.
1. WHat is the steel cone for and 2 do I need it and if so where to get them. I have 2 steel cones but need 4 assuming I need them at all and not just the 4 bolt hole gaskets
Thanks
-Mike

FIXX

iTrader: (2)

yes you need those steel cones,,call turbulators ,they will get hot from the exhausts heat and if water or mist from the tail pipes were to go into that section (reversion) those tabulators are supposed to burn off the water and turn it into steam so the exhaust can blow it out the tail pipe..

Cp performance has new ones available..

Sick Stinger

iTrader: (23)

Its a Dry pipe set up
What abbout the oil filter adpator housing gasket.
-Mike