Merc K-Plane 280 Cylider question
 

I currently have Lenco HD Sport Tabs (not the cheesy ones that come on cruisers) on my Velocity 260. They are fairly large and have heavy duty electric screw actuators. I was thinking of picking up a set of 280 K-Planes without cyliders, and using the electric screw actuators if they fit. Can someone post the k-Plane cylinder length both compressed and extended? Or post the measurement from bottom of k-plane to where the top of cylider mounts as well as distance from transom plate to where the bottom of cylider mounts. Thank you in advance!!!

TTT....

Still looking for measurements.........

think you would be better off using the full K-Planes, electric actuators more than likely not intended for that surface area.

My current tabs are not the typical Lenco tabs.... The hd sport tabs are quite large and may actually have more surface area than a 280 k-plane... Since they are stainless steel, they are probably much heavier than k_plane.... This is a pic before I mounted... These are 14"X18" for a total surface area of 252" inches each.....
http://site.activesportsunglasses.co...city/tabs3.jpg