Go Back  Offshoreonly.com > Technical > General Q & A
starting an engine that has set for a while >

starting an engine that has set for a while

Notices

starting an engine that has set for a while

Thread Tools
 
Old 07-25-2012, 04:12 PM
  #1  
Registered
Thread Starter
 
Join Date: May 2010
Location: Grand Rapids, Mi
Posts: 55
Likes: 0
Received 0 Likes on 0 Posts
Default starting an engine that has set for a while

I bought a 7.4 MPI over a year ago that I heard run before I got it and has been stored in my climate controled barn for the past year and half. I have it installed and am ready to start it. My question is should I do anything before I try, spray oil in the cylinders, anything to move the oil around? any help would be great Thanks Bman
gttdnbman is offline  
Old 07-25-2012, 06:12 PM
  #2  
Registered
 
28Eliminator's Avatar
 
Join Date: Dec 2001
Location: Rapid City SD
Posts: 809
Likes: 0
Received 0 Likes on 0 Posts
Default

Being in a climate controled shop should have helped a lot. You could spray in some oil just to help lube it. I would probably pull the plugs and wires off the distributor and spin it over until you get oil pressure. Then put plugs back in and fire it up.
28Eliminator is offline  
Old 07-25-2012, 06:52 PM
  #3  
Registered
iTrader: (1)
 
c_deezy's Avatar
 
Join Date: Aug 2006
Location: Ontario, OH
Posts: 2,465
Likes: 0
Received 0 Likes on 0 Posts
Default

Mine sat for a couple years, I pulled the distributor out and primed it with a drill before I fired it up.
c_deezy is offline  
Old 07-25-2012, 07:12 PM
  #4  
Registered
 
Join Date: Jan 2005
Location: Pasadena, MD
Posts: 3,570
Received 121 Likes on 39 Posts
Default

Pull the dist and spin the oil pump. Put a couple squirts of 10W-30 in through the plug holes, (put the distributer back in first) spin the motor by hand a couple rotations to make sure it was not stuck or had a sticking point and then let the starter spin it a few more times before letting it start.
Like said, climate controlled storage has extended it storage "shelf life" time by a lot.
f_inscreenname is offline  
Old 07-25-2012, 07:29 PM
  #5  
Registered
 
Join Date: Mar 2007
Location: Lake Dallas, TX
Posts: 1,087
Likes: 0
Received 0 Likes on 0 Posts
Default

Might want to replace your impeller, if they sit, they crack.
bert4332 is offline  
Old 07-26-2012, 01:27 AM
  #6  
Charter Member # 55
Charter Member
 
Griff's Avatar
 
Join Date: Oct 2000
Location: Omaha/LOTO
Posts: 19,558
Received 1,821 Likes on 907 Posts
Default

Originally Posted by 28Eliminator
Being in a climate controled shop should have helped a lot. You could spray in some oil just to help lube it. I would probably pull the plugs and wires off the distributor and spin it over until you get oil pressure. Then put plugs back in and fire it up.
Thats pretty much what I'd do. You really just need to pull the plugs and pull off the coil wire though.
Griff is offline  
Old 07-26-2012, 10:18 AM
  #7  
Registered
 
Join Date: Jan 2009
Posts: 6
Likes: 0
Received 0 Likes on 0 Posts
Default

I am in a similar situation, motor has not been run for a few months, stored inside, I plan on pulling the plugs, squirt a little oil in each hole, pull coil lead and turn the motor until I get oil to the top end. The one thing I am not sure about is, should I disconnect power to the electric fuel pump while doing this? I am thinking I will be "washing" the cylinders while priming the oil...??

Sorry to hijack but similar question......
fogducker III is offline  
Old 07-26-2012, 10:27 AM
  #8  
Registered
 
Join Date: Jan 2007
Posts: 1,667
Likes: 0
Received 0 Likes on 0 Posts
Default

Amazingly, most engines make same oil pressure at crank speed as the they do at idle with plugs OUT.

Plugs in, it's much harder to make pressure at crank speed.

You can test that info by putting a manual gauge on it and trying it both ways.
SDFever is offline  

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.