trim pump? 2 wire or 3 wire
#1
Registered
Thread Starter
iTrader: (1)
Join Date: Jan 2005
Location: New Orleans, LA
Posts: 159
Likes: 0
Received 0 Likes
on
0 Posts
trim pump? 2 wire or 3 wire
I'm replacing my trim pump set up on my 95 272 baja. I don't want to buy the wrong set up, so my question is how do you tell if you need the 2 wire or 3 wire set up?
Does it go my the # of wires coming out the pump motor itself, or do you go by the control connector which plugs to the relays? Thanks Robert
Does it go my the # of wires coming out the pump motor itself, or do you go by the control connector which plugs to the relays? Thanks Robert
#3
Two wire or three is referring to the wires coming out of motor .On two wire ,up or down is done by swapping polarity. On three wire the ground is third wire and you apply power to either of the other two for up or down .....Blue is up ,green is down .
A 95 merc pump is a three wire
A 95 merc pump is a three wire
#5
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
Two wire or three is referring to the wires coming out of motor .On two wire ,up or down is done by swapping polarity. On three wire the ground is third wire and you apply power to either of the other two for up or down .....Blue is up ,green is down .
A 95 merc pump is a three wire
A 95 merc pump is a three wire
#7
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
#8
Registered
Join Date: Jan 2011
Location: Toronto, Ontario, Canada
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
I didnt know there were 3 wire motors but it seems that if you wanted to use a 3 instead of a 2, all you would have to do is change the relay wiring to make them normal switches instead of polarity reversing.
Have a look at a 3 wire schematic and compare it to the 2 wire.
Have a look at a 3 wire schematic and compare it to the 2 wire.
#9
Registered
iTrader: (3)
I didnt know there were 3 wire motors but it seems that if you wanted to use a 3 instead of a 2, all you would have to do is change the relay wiring to make them normal switches instead of polarity reversing.
Have a look at a 3 wire schematic and compare it to the 2 wire.
Have a look at a 3 wire schematic and compare it to the 2 wire.
#10
Registered
Join Date: Nov 2001
Location: Pennsylvania
Posts: 3,385
Likes: 0
Received 0 Likes
on
0 Posts
I didnt know there were 3 wire motors but it seems that if you wanted to use a 3 instead of a 2, all you would have to do is change the relay wiring to make them normal switches instead of polarity reversing.
Have a look at a 3 wire schematic and compare it to the 2 wire.
Have a look at a 3 wire schematic and compare it to the 2 wire.