Blower pulley with serpentine acc belt
#3
Gold Member
Gold Member
iTrader: (4)
Join Date: Jan 2011
Location: Omaha Ne
Posts: 1,482
Likes: 0
Received 0 Likes
on
0 Posts
I would think B&M would have a kit for that, have you measured for clearance in the engine compartment? When the side mount whipple was installed in my Eliminator they had to move the rear seat forward about 2" Just a thought, Randy
#5
Registered
Use this pulley from CP.
http://www.cpperformance.com/p-14619...ock-chevy.aspx
It will accept any blower pulley of your chosing. You may or may not need a spacer between this pulley and the blower pulley. It depends on the length of the blower snout.
Eddie
http://www.cpperformance.com/p-14619...ock-chevy.aspx
It will accept any blower pulley of your chosing. You may or may not need a spacer between this pulley and the blower pulley. It depends on the length of the blower snout.
Eddie
#7
Registered
Gold Member
iTrader: (3)
Join Date: Jan 2011
Location: DeRidder, LA
Posts: 489
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=Old Navy;3888347]Generally, a blower like that has the blower belt and pulleys farther out than the accessory pulleys. [QUOTE]
That is how my setup is. I have the v-belts (502s) and then the bottom pulley attaches to the crank pulley so the blower belt is in front.
I can email you the instructions manual. The diagram of all the spacers is on the front page of it. Pm me your email if you would like me to send it.
You can see how it is setup on the front page of it. You can kind of see how mine is in the 2 pics I attached.
Jim
That is how my setup is. I have the v-belts (502s) and then the bottom pulley attaches to the crank pulley so the blower belt is in front.
I can email you the instructions manual. The diagram of all the spacers is on the front page of it. Pm me your email if you would like me to send it.
You can see how it is setup on the front page of it. You can kind of see how mine is in the 2 pics I attached.
Jim
Last edited by rgrgoog; 03-19-2013 at 07:23 PM.
#9
Registered
iTrader: (1)
Use this pulley from CP.
http://www.cpperformance.com/p-14619...ock-chevy.aspx
It will accept any blower pulley of your chosing. You may or may not need a spacer between this pulley and the blower pulley. It depends on the length of the blower snout.
Eddie
http://www.cpperformance.com/p-14619...ock-chevy.aspx
It will accept any blower pulley of your chosing. You may or may not need a spacer between this pulley and the blower pulley. It depends on the length of the blower snout.
Eddie