KE 2 piece valve covers LEAK!
#1
Registered
Thread Starter
iTrader: (3)
Join Date: Jun 2010
Posts: 884
Likes: 0
Received 0 Likes
on
0 Posts
KE 2 piece valve covers LEAK!
Did a search, but are there any other options out there to stop the leaking? i have 2 pair of them and If I have to silicone them down they are really not much use to me. Open to suggestions. Thanks!
#3
I hate the winter!!
Platinum Member
Join Date: Jul 2001
Location: long island, new york
Posts: 2,707
Likes: 0
Received 0 Likes
on
0 Posts
Those covers suck. Mine have leaked since new. Keith Eckert even talked me into buying a set of their NEW rails that were supposed to stop the leaks. They gave me some BS story that since I bought the covers from Trick Marine, they were most liklely rejects. Anyway, the new rails didnt work either. Now, I have mine silconed down. Need dynamite to get them off. In my case, I really dont care much anymore, since I switched to T&D shaft rockers, I dont have to adjust my valve lash anymore.
#5
Platinum Member
Platinum Member
We have used the KE valve covers fot 10+ years and they have never leaked a drop. We use the GM rubber VC gasket between the aluminum rail and the head. My suggestion is you call KEPP/Hardin and have a conversation.
#7
Registered
Thread Starter
iTrader: (3)
Join Date: Jun 2010
Posts: 884
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the info and link guys, Mine are good on the rail to head seal they seem to puddle oil on the lower rear top area of rail then leak past the o ring. They have a chamfer machined on the inside lower rail already I think.