Exhaust Turn Downs
#1
Platinum Member
Platinum Member
Thread Starter
Join Date: Nov 2005
Location: Tampa, FL/Milwaukee WI
Posts: 204
Likes: 0
Received 2 Likes
on
2 Posts
Exhaust Turn Downs
I need to do something about the decibels on my Outerlimits SV43. I'm looking at installing Gibson turn downs, any cautions or suggestions? Thanks
#2
Registered
Got any old mercruiser elbows around? Couple hunk of four inch hose and fake it. See what it is like before buying the shiny version. If you have to add length to get it below waterline, the oval merc hose is a wierd size. Not 4 inch.
Last edited by dereknkathy; 09-29-2017 at 05:27 PM.
#3
Registered
Join Date: Mar 2015
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
I have a set of crappy ones that you could borrow and tryout, I made them up to see if I liked them or not. turns out I didn't. The spray from the water and air is aggravating. they are 4"
P.M. and we could work something out.
P.M. and we could work something out.
#5
They are strict about noise where we boat and the CMI Sound Eliminators I had were still too loud at idle. I installed the Gibson downturns five years ago and haven't had any issues.
GF?
GF?
#6
I love my GGB inserts. They take about 6 dB off at idle and do not restrict rpm unlike some other inserts I've tried. 6 dB may not be enough for your but that was my experience from direct measurement.
The turn downs will work but turn down depth is important. They will splash a lot if not set deep enough. I made a test set out of 4" ABS drain pipe for concept evaluation.
The turn downs will work but turn down depth is important. They will splash a lot if not set deep enough. I made a test set out of 4" ABS drain pipe for concept evaluation.
#8
#10
Registered
I believe they make the inserts with up to 15-20 discs. That will REALLY quiet it down. I bought the 5 disc non competition inserts for my 496 (I know it's not that loud compared to other engines). They were too quiet. I cut 2 discs off. With 3 discs at cruise it is just as quiet as with the Corsa quiet exhaust on with no lose in speed. I was going to weld a bracket on the 2 discs I cut off and see how I liked the 2 disc setup, but haven't yet.