454/330 to 496 stroker
#1
Registered
Thread Starter
Join Date: Jul 2010
Location: Mentor, Ohio
Posts: 219
Likes: 0
Received 0 Likes
on
0 Posts
454/330 to 496 stroker
Would these heads work ok? http://pages.ebay.com/link/?nav=item...obalID=EBAY-US
If not does anybody have any other good suggestions around the same price? Also which cam would you recommend? I will be using performance manifolds or wet headers. I tried searching but couldn't find my exact setup and wasn't sure what would change. Motor will be all forged scat crank, pro comp rods and probe Pistons. Thank you in advance for any help.
If not does anybody have any other good suggestions around the same price? Also which cam would you recommend? I will be using performance manifolds or wet headers. I tried searching but couldn't find my exact setup and wasn't sure what would change. Motor will be all forged scat crank, pro comp rods and probe Pistons. Thank you in advance for any help.
#2
Registered
well since your going chinese,,might as well finish off the poopoo plater w/ those heads.but on a side note,those heads have springs for flat tappet cam.
#5
Gold Member
Gold Member
iTrader: (5)
Join Date: Oct 2005
Location: Olmsted Falls,Ohio Marblehead,Oh
Posts: 11,633
Likes: 0
Received 203 Likes
on
131 Posts
Buy a good set of name brand heads bare and have them built.... with good castings and good parts, proper springs for the application and INCONEL is a MUST....
I will never again buy ANY head assembled and bolt it on my boat engine, cars not a big deal so much but a boat is different story....
I will never again buy ANY head assembled and bolt it on my boat engine, cars not a big deal so much but a boat is different story....
#10
Registered