Promaxx 320 flow numbers
#11
Registered
Thread Starter
iTrader: (7)
I don't think you need to be worried about the quality of the castings. Jim and I spent a good half hour talking things over with Jason at ProMaxx at PRI. Jim fondled them for a bit also, he thought they looked pretty good for the $$$. There is a marine builder that has been using them for a couple of years with no issues. From their published flow #'s there might not be much work to do to them, but you never know. I stopped by after work today and I see he has a lot of new heads there to compare out of the box #'s to. New World Merlin, EQ320's, Dart 345's, Brodix SR-20's (F'n Huge!), some new Wieand tunnel rams and an Edelbrock single for the SR-20's. I'll stop by over the weekend and hopefully take a peak at your heads.
#13
Platinum Member
Platinum Member
iTrader: (6)
Are these the cast or aluminum heads
#16
Registered
#17
Registered