500 EFI No beep/fuel pressure
#1
Registered
Thread Starter
Join Date: Oct 2003
Location: Ballston Spa, New York
Posts: 524
Likes: 0
Received 9 Likes
on
7 Posts
500 EFI No beep/fuel pressure
I just replaced the wiring harnesses on both motors and now #2 does not beep and the fuel pump doesn't run when I turn the key. All the gauges on the dash work and the motor will crank when I turn the key. I have checked and jumped out the kill switch with no change. I swapped out both the relays near the ECM and checked that all grounds are attached. I don't know where else to look. Any help would be greatly appreciated
#2
Platinum Member
Platinum Member
iTrader: (6)
find this should have a grey cap on it, check fuses............also check the 50 amp fuse on the starter that wire takes all the voltage to the engie/EFI
EDIT: and make sure the shifter is in neutral
Last edited by F-2 Speedy; 04-17-2022 at 04:20 PM.
#3
Registered
Thread Starter
Join Date: Oct 2003
Location: Ballston Spa, New York
Posts: 524
Likes: 0
Received 9 Likes
on
7 Posts
i did check those three fuses and they are all good and I have checked that its in neutral. I don't think it would turn over if it was in gear. If that fuse on the starter were bad would it still turn over the motor?
#4
Platinum Member
Platinum Member
iTrader: (6)
no my bad on the neutral crank issue...........you replaced the engine wiring harness only ?