Any one know the cam specs and compression ratio for stock 502's?

Looking for specs on 1998 502 MPI motor

Thanks

8.75:1

[FloridianSon]

I'm showing GM cam #12551622 or Mer.#431-8510478 is 224 224 duration .483-.483 lift 115.5 LSA

Boy, are you ever missing out..... Here ya go, just click on the prop!

I removed a camshaft from a Gen VI Mercruiser engine with roller lifters and sent it to Comp Cams to be measured and it came back with the specs Floridian Son gave.
Dennis Moore

[audacity]

mine was in the VERY low 8's when we measured....most were under 8 1/2. this was pre 96 when i was doing these.

The cam spec given by findme 211-227 .511-.511 were used on the gen 5 engines ( im not sure about mkIV) the newer gen 6 are 224-224 .483-.483

built to spec ( blueprinted) CR should be 8.75, mine measured out at 8.78 however have been told by a merc rebuild depot the factory engines are all over 8.5 to 8.8

[mcollinstn]

My MkIV 502 service manual shows identical specs as the Gen6 (224/224 .483/.483).

OK Thanks to everyone for all the replies.

Okay, I'm confused.

My Gen6 service manual shows 511/511 lift and 211/227 duration. I believe the 483 lift cam is the Gen 5 cam.