Bravo1 Lower Unit - Torque Spec
#1
Registered
Thread Starter
Join Date: Feb 2001
Location: Portage,IN
Posts: 538
Likes: 0
Received 0 Likes
on
0 Posts
Bravo1 Lower Unit - Torque Spec
Anybody out there use a torque wrench to fasten
the lower to the upper drive unit on a BravoOne?
If so what would that torque measurement be?
"Sure do like those french fried 'tators" Emmpphh!!!
the lower to the upper drive unit on a BravoOne?
If so what would that torque measurement be?
"Sure do like those french fried 'tators" Emmpphh!!!
#2
The torque specs are 35 ft lbs. Keep in mind that a crowfoot would be needed for the recessed nuts, and the torque value spec need to be compensated for such.
I just tighten by hand, never any problems.
Your thinking to hard.
I just tighten by hand, never any problems.
Your thinking to hard.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.