330 rebiuld???
#1
speel chekk this fokker!
Charter Member
Thread Starter
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
330 rebiuld???
ok i havea a 330 sitting in my garage, its the old engine from my boat. My plan was to rebiuld it as a mild 3-4 psi blower motor.
After talkign to the machine shop it was determinded that i could reuse the cast crank and rods and block.
I was going to convert it to 4 bolt mains and put new forged pistons and replace eveythign else.
He figured it woudl be $2500 to do the shortblock (the heads were already redone prior to pulling the shortblock from the baot)
am i better of rebiulding it and sellign it as a mild blower motor or sellgin it as a 330 that might or might not need a rebiuld?
After talkign to the machine shop it was determinded that i could reuse the cast crank and rods and block.
I was going to convert it to 4 bolt mains and put new forged pistons and replace eveythign else.
He figured it woudl be $2500 to do the shortblock (the heads were already redone prior to pulling the shortblock from the baot)
am i better of rebiulding it and sellign it as a mild blower motor or sellgin it as a 330 that might or might not need a rebiuld?
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
#3
I did a lot of research on it and came to the conclusion that the 2 bolt block was just fine with arp studs up to about 650 hp. Assuming everything was done correctly of course.
#5
speel chekk this fokker!
Charter Member
Thread Starter
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
that was kinda of what iw as thinking.
loosk like i have a cheap 330 to sell.
loosk like i have a cheap 330 to sell.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!
#8
speel chekk this fokker!
Charter Member
Thread Starter
Join Date: Feb 2001
Location: Locust Valley, New York
Posts: 5,329
Likes: 0
Received 0 Likes
on
0 Posts
2 bolt yes. i was going to convert it to 4 bolt if i do teh rebiuld. I'm calling another machine shop tommorow owned by a friend of a friend. He might be able to come up with a better price than $2500 for doign a shortblock.
__________________
Pardon me, while I whip this out!
Pardon me, while I whip this out!