Will XR Drives fit on a ?
#1
Platinum Member
Platinum Member
Thread Starter
Will XR Drives fit on a ?
Will it fit on a standard bravo 1 Transom Assembly ?
Also is the Drive any longer or shorter than the
standard bravo 1 ?
This is for a single engine 29' Power Quest
with a 540 ci in it. I don't think the power
is as hard on the current Bravo as the weight
is.
Thanks for any help.
Cougarman
Also is the Drive any longer or shorter than the
standard bravo 1 ?
This is for a single engine 29' Power Quest
with a 540 ci in it. I don't think the power
is as hard on the current Bravo as the weight
is.
Thanks for any help.
Cougarman
#3
Charter Member
Charter Member
Join Date: Jan 2003
Location: GLOC
Posts: 1,345
Likes: 0
Received 0 Likes
on
0 Posts
#5
Registered
You also need to put a spacer in the trim cylinders to prevent U -joint from binding in the event you ran the engine in trailer position. The trim cylinder end cap is removed and a small plastic spacer is inserted to limit the trim up. Merc has a PN for the whole kit, gimble bearing, seal behind gimble bearing and limit for the cylinder. There may have been a piece for the bellows, can't remember but it had to do with clearance for the larger U-Joints.
Thread
Thread Starter
Forum
Replies
Last Post
dj_merk_e
Scarab
0
09-07-2007 07:48 PM
TeamPSI
General Q & A
7
03-31-2006 09:48 PM
Dean Ferry
General Boating Discussion
4
11-27-2002 08:09 AM