Changing shifter from single to dual
#1
Registered
Thread Starter
Join Date: Apr 2001
Location: muskegon, michigan
Posts: 586
Likes: 0
Received 0 Likes
on
0 Posts
Changing shifter from single to dual
Started on my project, changing from a single shifter, Quicksilver, to a dual handle, Morse. I figured it would'nt be a bolt on, nothing I do is and I'm right. the shifter ends are not the same. Do I need to re-cable?, or can I use these cables? anybody done this? Thanks, Buck
#2
Registered
Re: Changing shifter from single to dual
A.O. You will need to get new cables morse 33c cables I believe. You will need the adapter kit for both ends of the cables, not a bad job, you will like how they shift.
mark
mark
Thread
Thread Starter
Forum
Replies
Last Post
Michael1
General Q & A
3
03-05-2007 10:06 PM
littledcsrodshop
General Boating Discussion
4
11-16-2006 04:09 PM