What is this?
#1
Registered
Thread Starter
Join Date: Feb 2004
Location: Fruitland Park , FL
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
What is this?
I just took my prop off my bravo 1 and i noticed that there were this chunks of rubbers inside the lower where the shaft is, i got some pliers and took the rubber out also i saw in there and took off a little metal plate that looks like the bottom of an iron, im really puzzled about this finding, any help would be appreciated.
Carlos
Carlos
#6
Platinum Member
Platinum Member
Re: What is this?
Definitely.
I was assuming you were NOT running exhaust thru the lower unit. Apparently you ARE running exhaust thru the lower unit and that is indeed an exhaust piece.
I was assuming you were NOT running exhaust thru the lower unit. Apparently you ARE running exhaust thru the lower unit and that is indeed an exhaust piece.
#8
Official OSO boat whore
Charter Member
iTrader: (2)
Join Date: Oct 2000
Location: Mequon, WI
Posts: 6,157
Likes: 0
Received 0 Likes
on
0 Posts
Re: What is this?
That sure looks like a flapper disk. The port is oblong like that. If you never had through prop exhaust, maybe the drive was on a boat that did?
#9
Charter Member#157
Charter Member
Join Date: Oct 2000
Location: Minneapolis, Mn, Usa
Posts: 1,859
Likes: 0
Received 3 Likes
on
3 Posts
Re: What is this?
just because you are running thu hull does not leave out that you may still be running thru prop also
do you have the Y-Pipe?
I currently run both the y-pipe and Thru hull
so its possible
do you have the Y-Pipe?
I currently run both the y-pipe and Thru hull
so its possible
__________________
This Cat is trying to keep up with the Big Dogs
This Cat is trying to keep up with the Big Dogs
#10
Registered
iTrader: (2)
Re: What is this?
I just replaced that Y-pipe flapper yesterday. That's exactly what it is.
If you do have a Y-pipe, you will want to replace the flappers. There is one on each side where the Y-pipe hoses connect the thru-hull pipe together. My flapper broke and it ended up letting water come back up through it, and filled my cylinders with water hydrolocking the motor.
If you do have a Y-pipe, you will want to replace the flappers. There is one on each side where the Y-pipe hoses connect the thru-hull pipe together. My flapper broke and it ended up letting water come back up through it, and filled my cylinders with water hydrolocking the motor.