Intake Part#
#1
Registered
Thread Starter
Join Date: Mar 2004
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Intake Part#
I took my carb off today and found the chevy part number on my intake manifold. PN 333841 I tried to find the number on the internet but failed. Can anyone help identify this intake? Its on a mark IV 454.
#7
Registered
Thread Starter
Join Date: Mar 2004
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
Re: Intake Part#
Open72, you are a man of much knowledge!
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
#8
Registered
iTrader: (2)
Re: Intake Part#
Originally Posted by Hostile Takeover
Open72, you are a man of much knowledge!
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
Do you know if it has brass inserts in the water passages? Is it a good manifold. I am doing an upgrade to DANA exhaust manifolds and a roller cam. Would you replace it with a high rise?
ya , it has the inserts. i am actually using the same intake with a 2 inch spacer . going on a 540 with a crane 731 roller. what kinda boat/drive?
Last edited by open87; 02-07-2005 at 09:53 PM.