Anyone in Ontario Canada that can modify CMI Tailpipes
#1
Airking
VIP Member
Thread Starter
Join Date: Aug 2004
Location: Stafford Va.
Posts: 452
Likes: 0
Received 0 Likes
on
0 Posts
Anyone in Ontario Canada that can modify CMI Tailpipes
Looking for someone to install and adjust flanges on CMI tailpipes in Bobcaygeon Canada area. Going from CMI elbow tops to CMI sweeper style headers. I need new flanges put on and flange angle adjusted on tailpipes. Looking for someone in Ontario area that can perform this service. Thanks
#3
VIP Member
VIP Member
Join Date: Sep 2005
Location: Marco Island, FL; Waterloo, ON, CAN
Posts: 5,736
Received 121 Likes
on
21 Posts
Try DoubleR Performance in Orillia, ON. The office is 705 487 7575. They may be able to refer you to someone and if not, they will probably have to go back to CMI. Good luck with that !
Bob
Bob
#5
Registered
If Double R can't do it then try "Slingsby Boating"
Doug Slingsby 416-606-3909 in Toronto works on all kinds of high performance boats and may be able to do it?
Another guy might be Norm Edmunston of Sunshine Marine at 647-209-0173. He is in Etobikoke and also works on high performance marine.
Doug Slingsby 416-606-3909 in Toronto works on all kinds of high performance boats and may be able to do it?
Another guy might be Norm Edmunston of Sunshine Marine at 647-209-0173. He is in Etobikoke and also works on high performance marine.
#6
Registered
#7
Registered
Try Steve Wamboldt of "Wamboldt Manufacturing" in Niagara on the Lake 905-262-6776.
Steve can manufacture or weld anything! The guy is amazing!
He builds car frames and does boat work as well. He used to own a Chris Craft jet with a big block and made almost everything on the boat including engine mounts exhasut and drive installation.
Steve can manufacture or weld anything! The guy is amazing!
He builds car frames and does boat work as well. He used to own a Chris Craft jet with a big block and made almost everything on the boat including engine mounts exhasut and drive installation.