teaguecustommarine

I have a ton of misc parts all over the shop and before this place gets out of control (like its not already there) I need to move some of this stuff out of here. i will be posting everyday so if there
is something you want that you see, don't wait, cause its probably the only one that i have and when its gone its gone. OHHHand if you need something that I don't have posted just let me know and i will check to see if i have it . OK with all that said.....
Gentlemen start your engines

teaguecustommarine

It's like i always say "WE INSTALL EVERYTHING WE SELL" so with the amount of boats with 496 engines that come through here we TAKE OFF parts and upgrade, in this case we are upgrading exhaust systems to the CMI headers.
I HAVE 4 PR OF GOOD TAKE OFF MERCURY EXHAUST MANIFOLDS AND RISERS
manifold #863120T2 $498.92
riser #865331A01 $616.29
I NEED THESE GONE, SO HOW ABOUT $350.00pr
and remember, I only have 4pr

Wally

iTrader: (1)

have anything as far as exhaust goes for SBC??

teaguecustommarine

GOT CANS? we do and I guess since these are available anywhere
you would think that they are gonna cost ya a small fortune....
Well the answer would have to be NO! $10.00 and its
yours OHHH and if there are any of you out there that have
broken power steering tank rear studs (it happens) we got those
also, and it's not those merc replacement studs, they are the real from the factory studs $5.00 each

teaguecustommarine

I AM OUT OF THESE BUT I AM GOING TO LEAVE
THIS UP FOR WHEN I GET MORE. i will keep you all posted.
new take off Trim Pump tanks
got a box full of these and what i need
is a empty box of these so how about $10.00 ea.

teaguecustommarine

As a matter of fact I just happen to have a really good set that could be yours for the low low price of $300.00 for the pair. saweet
let me know

Wally

iTrader: (1)

The ones you have pictured are the 4 bolt type....have any witht he singe screw from the center bottom??

teaguecustommarine

sorry i think thats pretty much all i got for small block as far as exhaust goes. I will look again and let you know.

djtalon

where can i get the stainless plates taht block off the pivot pins when you remove the trim senders?

thanks

Wally

iTrader: (1)

Actually i was refering to the trim pump tanks on that post....