24 race redo
06-30-2011, 01:25 PM
#42
Registered
iTrader: (5)
Join Date: Aug 2010
Location: MA
Posts: 2,535
Likes: 0
Received 0 Likes
on
0 Posts
I'm about ready to dive into the same project. Filling transom hole from trs. Plan to cut bravo hole. Anyone have advice what's a good height if I run a standard dwp bravo?
06-30-2011, 07:14 PM
#44
Registered
iTrader: (5)
Join Date: Aug 2010
Location: MA
Posts: 2,535
Likes: 0
Received 0 Likes
on
0 Posts
Starting my own thread soon so stay tuned. Hoping to have her done by Oct - Nov .
This is the 3 man racer previously raced by MER performance in the mid / late 90's
Restoring her to one bad az$ pleasure / p.r. Boat
08-08-2011, 07:25 AM
#46
Getting there. I'm hoping a couple weeks. Doing some wiring, rigging, etc. in bilge. Also redoing nose cone and painting drive. Got to get those done so I can put new steerng on...then drop engine in and hook up. Oh yeh and drop in new/temp. gas tank too. Pics to come later
08-08-2011, 09:02 AM
#47
Registered
iTrader: (5)
Join Date: Aug 2010
Location: MA
Posts: 2,535
Likes: 0
Received 0 Likes
on
0 Posts
mike
08-25-2011, 09:56 PM
#48
horrible pic...only got one because it got late. Drive rebuilt. Cleaned up whole drive and also new epoxy on nose cone and fresh paint. Came out really good. 95% rigging done in engine compartment (sorry no pics yet). Engine to go in Mon., Tues. New rams mounted (almost) and getting closer...shooting for Labor Day. Will get better pics next week.
