Water Temp gauge on Enticer
07-30-2007, 09:20 AM
#1
Registered
Thread Starter
Join Date: Jan 2002
Location: Lake St Clair Metropark, Harrison Township, MI
Posts: 257
Likes: 0
Received 2 Likes
on
2 Posts
Water Temp gauge on Enticer
Just curious what you guys are reading on your temp gauges while running. I'm at 180, seem a little high?
07-30-2007, 10:59 AM
#2
Registered
Join Date: Jun 2004
Location: Wichita, KS
Posts: 269
Likes: 0
Received 0 Likes
on
0 Posts
I run 180 on mine when I am on it, slightly below when I am cruising and it bumps to 190ish when I come off plane and then cools off back to just below 180 on my gauges.
Both motors are the same temp. One warm sup slightly faster than the other but once they are up to temp they are dead even
I have 502Mags MPI
Both motors are the same temp. One warm sup slightly faster than the other but once they are up to temp they are dead even
I have 502Mags MPI
Last edited by ckentling; 07-30-2007 at 04:00 PM.
07-30-2007, 11:29 AM
#3
Registered
Going by my factory Faria gauges I am just under the 175 degree mark.I was told to use the electric gauges more for comparison/watching for changes than counting on them for a hard number.
07-30-2007, 01:30 PM
#4
Registered
You are fine at 180. None of these gauges are very accurate.
07-30-2007, 08:24 PM
#6
Registered
Join Date: Jan 2007
Location: Villa Grove, Ill
Posts: 88
Likes: 0
Received 0 Likes
on
0 Posts
I run 180 on mine when I am on it, slightly below when I am cruising and it bumps to 190ish when I come off plane and then cools off back to just below 180 on my gauges.
Both motors are the same temp. One warm sup slightly faster than the other but once they are up to temp they are dead even
I have 502Mags MPI
Both motors are the same temp. One warm sup slightly faster than the other but once they are up to temp they are dead even
I have 502Mags MPI
Dave
Last edited by Dave Kline; 07-30-2007 at 08:25 PM. Reason: typo
