New to me and first real boat 290 Enticer FX
#11
Registered
Thread Starter
Join Date: Oct 2012
Location: Sullivan, Wi
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
I will try to stop by Crater Island we should have plenty of time that day. As for the PQ Fun Run that will be difficult with having the week before off.
New Decals came in last night UPS I will get some pics up once they are on the boat.
New Decals came in last night UPS I will get some pics up once they are on the boat.
#15
Registered
Thread Starter
Join Date: Oct 2012
Location: Sullivan, Wi
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Drive showers and decals went on today also wired in the remote display for my sony marine radio. I think the decals should have gone in a different place but to late now. As for the drive showers they seem to work and fit ok, they are mayfair showers, not as nice as the Simrek but I purchased 2 mayfair for the price of one Simrek. I would not install these on a 100k boat but they are just fine for my $9500 boat.
#16
Registered
Thread Starter
Join Date: Oct 2012
Location: Sullivan, Wi
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Im a bit late on my updates. Ice is on my lake now and sleds are ready to go. The boat ran great on the mississippi. I have an issue with my port trim pump allowing the drive to droop and lower after a day or so also the drive will drop all the way in when trimmed down under power. I plan to pull the pump and inspect valves and such. Im also getting ready to replace the starbord motor. Still runs great and builds decent oil pressure but when idling or during start up the exhaust tone is noticeably different. Im certain compression is less than desirable. Any recommendations on rebuilt/exchange engines?