Cutting Edge Props on 29 Outlaw
04-30-2012, 08:58 AM
#1
Registered
Thread Starter
Cutting Edge Props on 29 Outlaw
Finally had a chance to run the new props for a couple passes yesterday (Sunday) before the weather (wind) got out of control down here again. Props were Bravo 1 28's...Temps in the low 80's, typical Houston humidity and overcast out. Mid-range acceleration was amazing and top end was 78.9-79 at 5100 RPM. Very happy with the overall set up and thank you to Greg with Cutting Edge Propellers...great guy to deal with.
04-30-2012, 01:31 PM
#3
Registered
Thread Starter
46 @ 3500. What was the most amazing was the handling and the mid-range acceleration. Even my wife who knows squat other then how to look pretty on the boat said "wow". For stock black motors from say 3-3500 and showering down on the throttles it would put you back in the bolster.
Last edited by HOSSMAN; 04-30-2012 at 02:01 PM.
Platinum Member
04-30-2012, 06:14 PM
#5
Registered
Thread Starter
In my testing in cool 60-70* low humidity weather 4900/78, in the heat was 47-4800 and 75-76. Props have been re-done a few times.
I only made 3 passes before the weather got too bad so I still need to fine tune but overall very happy with the overall results thus far.
I only made 3 passes before the weather got too bad so I still need to fine tune but overall very happy with the overall results thus far.
Last edited by HOSSMAN; 04-30-2012 at 06:22 PM.
