Saber 28 Guys
#1
Gold Member
Gold Member
Thread Starter
Join Date: Oct 2000
Location: Erie, PA US
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
Saber 28 Guys
I just did a mock up for a windscreen i am having made! I am very excited about this project as we all know these boats are a tad windy! I will keep all of you posted as some of you already expressed some intrest in this project as well! I hope to have it in time for the saber rally!
#4
Gold Member
Gold Member
Thread Starter
Join Date: Oct 2000
Location: Erie, PA US
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
Eric,
here are a few more pictures
[ATTACH=CONFIG]504218[/ATTACH][ATTACH=CONFIG]504219[/ATTACH][ATTACH=CONFIG]504220[/ATTACH][ATTACH=CONFIG]504221[/ATTACH]
here are a few more pictures
[ATTACH=CONFIG]504218[/ATTACH][ATTACH=CONFIG]504219[/ATTACH][ATTACH=CONFIG]504220[/ATTACH][ATTACH=CONFIG]504221[/ATTACH]
#5
Registered
Looks good, is it going to mount on the small lip right below the top of the fairing or does it go further down? Also is it curved back from the center toward each side to match or does it just flex into place? I want one, and will probably get one once I see it in person but then I will have to have my covers redone.
#6
Gold Member
Gold Member
Thread Starter
Join Date: Oct 2000
Location: Erie, PA US
Posts: 997
Likes: 0
Received 0 Likes
on
0 Posts
it will bolt onto the lip, and its all custom fit. i will bring the mock up cardboard for you to fit on your boat next weekend. there is no flexing. Its hard to see in the pictures all the curves that are in this.
i am going to have a pocket made in my cover my nice blue cover. i have an old gray cover that i will use this weekend, i fits really loose and sloppy and i think will work just fine
i am going to have a pocket made in my cover my nice blue cover. i have an old gray cover that i will use this weekend, i fits really loose and sloppy and i think will work just fine