Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 2
1
2
Search: Posts Made By: murdered6.2
Showing results 1 to 25 of 40
Search took 0.00 seconds.
Forum: Trucks, Trailers and Transportation
09-09-2010, 08:34 AM
Replies: 57
Views: 17,300
Posted By murdered6.2

What was your IPR percentage? When you remove...

What was your IPR percentage? When you remove the IPR valve inspect the screen on the front for damage and if damaged might want to remove the oil cooler and replace the screen under the oil cooler....
Forum: General Q & A
09-08-2010, 09:20 AM
Replies: 29
Views: 15,975
Posted By murdered6.2

yes the fuel pump is a mechanical diapharm type...

yes the fuel pump is a mechanical diapharm type pump that was putting out way too much pressure at higher rpms. I think someone on here said they had to shim theirs and it fixed the same problem. ...
Forum: General Q & A
09-08-2010, 09:00 AM
Replies: 6
Views: 2,641
Posted By murdered6.2

Hissing noise would mostlikely be a vacume leak...

Hissing noise would mostlikely be a vacume leak but that would cause a lean engine unless its a vacume leak to the map sensor which could cause the engine to run rich. Dark or black smoke would be...
Forum: Baja
09-07-2010, 06:15 PM
Replies: 2
Views: 1,283
Posted By murdered6.2

I have the cock pit cover Its just the wrong...

I have the cock pit cover Its just the wrong color. Im getting the boat painted blue this winter and i want a blue cover. What if i send you the original cover and you make me a blue one?
Forum: General Q & A
09-07-2010, 01:25 PM
Replies: 29
Views: 15,975
Posted By murdered6.2

Thanks i ordered a holley red pump and regulator...

Thanks i ordered a holley red pump and regulator with pressure gauge today. I will just block off the fuel pump on the sea pump.
Forum: Baja
09-06-2010, 05:05 PM
Replies: 2
Views: 1,283
Posted By murdered6.2

Hammer fuel tank cover.

I have a 1997 baja hammer and the fuel tank cover section in the floor moves down under your feet when you walk on it. Is there a way to fix this or do I have to replace the whole piece? Does this...
Forum: General Q & A
09-06-2010, 04:54 PM
Replies: 0
Views: 747
Posted By murdered6.2

Trim and depth gauge help needed.

Now that the high fuel pressue issue has been figured out and i can trust the engine not to flood out any more and leave me stranded I have a few other things wrong and I was wondering if anyone migh...
Forum: General Q & A
09-06-2010, 04:07 PM
Replies: 29
Views: 15,975
Posted By murdered6.2

FIXED! tested fuel pressure! was getting over 12...

FIXED! tested fuel pressure! was getting over 12 psi above 3200 rpm the gauge stopped at 12 so i dont know what it was really reading. Installed a fuel pressure regulator and regulated to 6 psi and...
Forum: General Q & A
08-23-2010, 08:11 PM
Replies: 29
Views: 15,975
Posted By murdered6.2

Well Im working on adapting my fuel pressure...

Well Im working on adapting my fuel pressure tester to it right now. The Boat has a nice stainless hard line from the pump to the carburetor and i hate to cut it so im working on getting the proper...
Forum: General Q & A
08-23-2010, 07:59 PM
Replies: 5
Views: 4,968
Posted By murdered6.2

Tall deck is for generally used for longer...

Tall deck is for generally used for longer strokes to create more displacement. A tall deck is needed so you can run a longer rod to make a more favorable rod to stroke ratio, the lower the ratio...
Forum: Trucks, Trailers and Transportation
08-23-2010, 04:13 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

We already established that he has a biased icp...

We already established that he has a biased icp sensor with his koeo icp voltage reading by checking PID data. I do believe i stated that the ICP issue was probably the main cause of this concern in...
Forum: Trucks, Trailers and Transportation
08-23-2010, 09:39 AM
Replies: 57
Views: 17,300
Posted By murdered6.2

EP Is not just a plug even with the infered...

EP Is not just a plug even with the infered strategy. It can still cause problems even if the pcm is ignoring what it is reading. EP sensor can still short Vref intermittantly and cause...
Forum: General Q & A
08-20-2010, 10:59 AM
Replies: 29
Views: 15,975
Posted By murdered6.2

hmmmmm... I might try that! thanks! You guys are...

hmmmmm... I might try that! thanks! You guys are a lot more helpfull than anyone I have talked to. being that this boat has a mechanical fuel pump and that it doesnt have a fuel pressure regulator,...
Forum: Trucks, Trailers and Transportation
08-20-2010, 10:53 AM
Replies: 55
Views: 8,814
Posted By murdered6.2

Subscribed! This is getting interesting!

Subscribed! This is getting interesting!
Forum: General Q & A
08-19-2010, 03:55 PM
Replies: 29
Views: 15,975
Posted By murdered6.2

Ok so i rebuilt the sea pump and installed new...

Ok so i rebuilt the sea pump and installed new edelbrock 750 cfm marine carburetor. I went with edelbrock because its a direct bolt on, sorry but i didnt feel like making a new bracket for the...
Forum: Trucks, Trailers and Transportation
08-19-2010, 03:41 PM
Replies: 10
Views: 4,845
Posted By murdered6.2

12" drop is excessive for a tow rig by far! A...

12" drop is excessive for a tow rig by far! A full bagged set up will handle the weight if equiped with the right bags. There are a few around here that have air bar suspensions that handle...
Forum: Trucks, Trailers and Transportation
08-19-2010, 03:33 PM
Replies: 16
Views: 1,405
Posted By murdered6.2

Truck stops are the best places to get fuel. ...

Truck stops are the best places to get fuel. Never stop at a station that you never see diesels there refueling. chances are the diesel they have stored in their tanks isnt refreshed with new fuel...
Forum: Trucks, Trailers and Transportation
08-19-2010, 01:12 PM
Replies: 16
Views: 1,405
Posted By murdered6.2

6.4 power stroke isnt any better than 6.0 in my...

6.4 power stroke isnt any better than 6.0 in my opinion. They are a hell of a lot more expensive to work on and a hell of a lot harder to work on! the new 6.7 however is off to a great start!
...
Forum: Trucks, Trailers and Transportation
08-19-2010, 12:44 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

(EP) is Exhaust Pressure. or Exhaust back...

(EP) is Exhaust Pressure. or Exhaust back pressure (EBP) Just follow the tsb to the letter and then we will work on the icp issue.
Forum: Trucks, Trailers and Transportation
08-18-2010, 01:46 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

Injector Control Pressure Sensor:...

Injector Control Pressure Sensor: 3c3z-9f838-ea/157.50
Wire Connector: 5c3z-12224-a/73.47
Exhaust Backpressure Sensor: 4c3z-9j460-a/111.27

Sorry your having trouble with the dealer you are...
Forum: Trucks, Trailers and Transportation
08-18-2010, 01:32 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

I dont know its not descriptive enough. you may...

I dont know its not descriptive enough. you may be able to call the dealer and ask them what their history says in their computer. This is probably the least descriptive labor claims report i have...
Forum: Trucks, Trailers and Transportation
08-18-2010, 01:30 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

thats all the warranty history on your truck. no...

thats all the warranty history on your truck. no open recalls on it.

Had I known you had full shop with all tools we would have dealt with this a bit differently. You always follow KOEO codes...
Forum: Trucks, Trailers and Transportation
08-18-2010, 01:17 PM
Replies: 57
Views: 17,300
Posted By murdered6.2

Standard Claims List For Model Year 2003 ...

Standard Claims List For Model Year 2003
Detailed Vehicle Specification

--------------------------------------------------------------------------------


VIN VEH LINE MKT DERIV BODY CAB...
Forum: Trucks, Trailers and Transportation
08-18-2010, 11:35 AM
Replies: 57
Views: 17,300
Posted By murdered6.2

r8pd 8p. make sure you have the latest...

r8pd 8p. make sure you have the latest calibration in the pcm by taking it to a dealer and having them check it and if not latest calibration have them install the latest calibration.
Forum: Trucks, Trailers and Transportation
08-18-2010, 11:33 AM
Replies: 57
Views: 17,300
Posted By murdered6.2

quite possibly being that you have had a recent...

quite possibly being that you have had a recent turbo rebuild. that tsb could apply to you. im not sure whats out there for independent shops to perform the turbo learn procedure so that may have...
Showing results 1 to 25 of 40
 
Page 1 of 2
1
2


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.