Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: PROFAB
Showing results 1 to 8 of 8
Search took 0.01 seconds.
Forum: Swap Shop
08-16-2011, 08:41 AM
Replies: 14
Views: 1,962
Posted By PROFAB

cert

Needs to have funny car cage to pass 7.50 cert. It should pass 8.50 cert. You should have it certified-would add interest to the sale.
Forum: General Q & A
08-09-2011, 11:54 AM
Replies: 6
Views: 1,340
Posted By PROFAB

Mount them below the bottom of the tank, in most...

Mount them below the bottom of the tank, in most applications you can get them in the deepest part of the bilge. Put them as close to the tank as possible.
Forum: General Q & A
08-09-2011, 04:27 AM
Replies: 6
Views: 1,340
Posted By PROFAB

a1000 pumps

If these pumps are run with the slightest bit of air aerated with the fuel it will tear them up almost immediately. As with all geroter or vane pumps they should only be fed from a sump on the bottom...
Forum: Drives and Lower Units
08-08-2011, 11:14 AM
Replies: 6
Views: 1,210
Posted By PROFAB

X2

X2
Forum: General Q & A
08-08-2011, 11:11 AM
Replies: 9
Views: 1,573
Posted By PROFAB

Smile forced induction

I wouldnt reccomend running any boost into that engine with lower octane fuel unless an aftermarket engine management system is installed. The factory system installed on your MPI only utilizes a 1...
Forum: Swap Shop
08-07-2011, 10:11 PM
Replies: 6
Views: 712
Posted By PROFAB

3s

Are these 3s or 3a's? Would you be able to post pics or Email to: [email protected]

thanks
Forum: Drives and Lower Units
08-07-2011, 09:48 PM
Replies: 6
Views: 1,210
Posted By PROFAB

speedmaster 4

You would need to remove the bravo gimbal and replace it with the speedmaster gimble, which involves cutting the transom opening larger. If you did not want to move the engine forward, an extension...
Forum: Swap Shop
07-18-2011, 02:06 AM
Replies: 2
Views: 499
Posted By PROFAB

MPI parts

Please send pictures of the upper and lower intake if possible to [email protected]

thanks
Showing results 1 to 8 of 8


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.