Offshoreonly.com - Search Results

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Notices
 
Search: Posts Made By: splashandburn
Showing results 1 to 25 of 500
Search took 0.03 seconds.
Forum: Swap Shop
01-05-2024, 05:06 PM
Replies: 0
Views: 237
Posted By splashandburn

Procharger pulleys

8 Rib Procharger Supercharger pulleys with offset. There are two each of the following: 3.0", 3.7", 4.0" and 4.13". Price is $50 each pulley with free shipping.
Forum: General Q & A
11-06-2023, 07:38 PM
Replies: 8
Views: 301
Posted By splashandburn

I'mdoing this on a 46 Black Thunder

I'mdoing this on a 46 Black Thunder
Forum: General Q & A
11-06-2023, 07:38 PM
Replies: 8
Views: 301
Posted By splashandburn

So I'm assuming your flange is on the inside of...

So I'm assuming your flange is on the inside of the hull, not outside?
Forum: General Q & A
11-06-2023, 07:36 PM
Replies: 8
Views: 301
Posted By splashandburn

Inwas planning to resin or epoxy over the exposed...

Inwas planning to resin or epoxy over the exposed cut and was thinking of using MarineTex to seal it all in. Itl be pretty permanent but I don't see how else to.seal of all up really well.
Forum: General Q & A
11-06-2023, 04:57 PM
Replies: 8
Views: 301
Posted By splashandburn

They still need to be cut. Just received them...

They still need to be cut. Just received them from Teague.
Forum: General Q & A
11-06-2023, 04:38 PM
Replies: 8
Views: 301
Posted By splashandburn

Attached a photo. There is a flange but only on...

Attached a photo. There is a flange but only on the inside of the boat - nothing goes outside.
Forum: General Q & A
11-06-2023, 03:53 PM
Replies: 8
Views: 301
Posted By splashandburn

Water pick ups

I'm in the process of adding water pick ups for Whipples. I can't go thru the transom so I'm going to have to go thru the bottom of the boat. My question is how to I seal everything up once I go thru...
Forum: General Q & A
10-30-2023, 04:36 PM
Replies: 11
Views: 1,346
Posted By splashandburn

So I'm going to have to go thru the bottom of the...

So I'm going to have to go thru the bottom of the boat and not the transom for the pick ups. Anyone know how close to the center of the hull I can go? I've for other thru hull fittings I'm trying to...
Forum: General Q & A
10-24-2023, 08:38 PM
Replies: 11
Views: 1,346
Posted By splashandburn

yes, I was concerned with the colder temps at...

yes, I was concerned with the colder temps at idle running thru the intercooler and keeping the motor too cold. Sounds like your "check valve" worked in your application. Thanks
Forum: General Q & A
10-24-2023, 07:48 PM
Replies: 11
Views: 1,346
Posted By splashandburn

What others ways are you thinking other than 2...

What others ways are you thinking other than 2 stage pumps? Intercoolers will dump out the side. Already holes there for them.
Forum: General Q & A
10-24-2023, 07:03 PM
Replies: 11
Views: 1,346
Posted By splashandburn

Thanks, that's what I was hoping for. I know...

Thanks, that's what I was hoping for. I know Whipple is looking for specific pressures on the block, is that the case with the intercooler as well?
Forum: General Q & A
10-24-2023, 09:31 AM
Replies: 11
Views: 1,346
Posted By splashandburn

Adding Whipple's

I am in the process of adding 3.8L Whipple's and have a question on cooling. I plan to add external pick ups plumbed into my water pump to feed the motors and plan to use the drive (IMCO SCX with SC...
09-12-2022, 05:22 PM
Replies: 0
Views: 531
Posted By splashandburn

Nor-tech 5000 SV

Looking for a 5000 SV - any out there coming up for sale?
Forum: General Q & A
04-17-2022, 09:05 PM
Replies: 4
Views: 587
Posted By splashandburn

yes and all battery cables to both motors....

yes and all battery cables to both motors. Basically new ground and positive cables.
Forum: General Q & A
04-17-2022, 07:28 PM
Replies: 4
Views: 587
Posted By splashandburn

i did check those three fuses and they are all...

i did check those three fuses and they are all good and I have checked that its in neutral. I don't think it would turn over if it was in gear. If that fuse on the starter were bad would it still...
Forum: General Q & A
04-17-2022, 11:17 AM
Replies: 4
Views: 587
Posted By splashandburn

500 EFI No beep/fuel pressure

I just replaced the wiring harnesses on both motors and now #2 does not beep and the fuel pump doesn't run when I turn the key. All the gauges on the dash work and the motor will crank when I turn...
10-25-2021, 02:25 PM
Replies: 4
Views: 904
Posted By splashandburn

Thanks - ordered one today

Thanks - ordered one today
10-25-2021, 02:24 PM
Replies: 4
Views: 904
Posted By splashandburn

thanks for the info

thanks for the info
10-24-2021, 03:57 PM
Replies: 4
Views: 904
Posted By splashandburn

IMCO SC lower muff

What does everyone use for a muff on the IMCO SC lower?
Forum: General Q & A
10-03-2021, 08:46 PM
Replies: 4
Views: 1,297
Posted By splashandburn

You can also try adjusting the selenoid rods first

You can also try adjusting the selenoid rods first
Forum: General Q & A
10-03-2021, 08:45 PM
Replies: 4
Views: 1,297
Posted By splashandburn

ive had this happen on a couple boats and ended...

ive had this happen on a couple boats and ended up putting weaker spings on the selenoids. Go the the local hardware store and find something weaker - works great and has for years
Forum: Black Thunder
09-09-2021, 07:49 PM
Replies: 2
Views: 1,535
Posted By splashandburn

Haha way more than that before it's loaded

Haha way more than that before it's loaded
Forum: Black Thunder
09-08-2021, 11:40 AM
Replies: 2
Views: 1,535
Posted By splashandburn

46EC weight

Anyone know the dry weight of a 46EC with twins?
Forum: Fountain
09-06-2021, 09:20 PM
Replies: 0
Views: 359
Posted By splashandburn

Any 48 EC's for sale?

Any 48 EC's out there for sale that aren't listed yet? I know there's one in Texas right now but any others that might be coming up for sale?
Forum: Outerlimits
08-30-2021, 08:19 PM
Replies: 6
Views: 1,929
Posted By splashandburn

Sent you a pm

Sent you a pm
Showing results 1 to 25 of 500
 


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.