Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
 
Page 1 of 4
1
2
3
Last »
Search: Posts Made By: Yoda_Man
Showing results 1 to 25 of 100
Search took 0.01 seconds.
Forum: General Q & A
11-27-2014, 01:59 PM
Replies: 17
Views: 1,804
Posted By Yoda_Man

fortress anchors are nice and lite and work well

fortress anchors are nice and lite and work well
Forum: Baja
11-27-2014, 08:00 AM
Replies: 5
Views: 760
Posted By Yoda_Man

that was my plan but i havnt done it yet. I also...

that was my plan but i havnt done it yet. I also installed a holding tank under the drivers floor and a head with a macerator. I used the area between the head and the driver area to store my...
Forum: Baja
11-25-2014, 07:46 AM
Replies: 5
Views: 760
Posted By Yoda_Man

if you look closely at the trim its nailed in...

if you look closely at the trim its nailed in place so you have to carefully pry it off then your tv will slide out

i turned mine into a cupboard along with where the microwave was
Forum: Baja
07-13-2014, 05:20 PM
Replies: 5
Views: 2,230
Posted By Yoda_Man

hey XT do you know which boats share a windshield...

hey XT do you know which boats share a windshield with a 97 322?

thanks

neil

sorry for the hijack!
Forum: Baja
07-06-2014, 06:36 PM
Replies: 3
Views: 985
Posted By Yoda_Man

there is a small seal on the bearing side of the...

there is a small seal on the bearing side of the stainless plate that is probably leaking. you can buy them seperatly from merc from the entire pump i think they come in a two pack cause there are...
Forum: General Boating Discussion
05-15-2014, 09:42 AM
Replies: 31
Views: 4,286
Posted By Yoda_Man

ive got a pretty extensive collection of the...

ive got a pretty extensive collection of the Makita 18V tools and i love them. the half inch impact takes the lug nuts off my ctd and crawler 1 ton lugs with ease. cordless grinder always comes in...
Forum: Drives and Lower Units
05-07-2014, 06:34 PM
Replies: 4
Views: 1,141
Posted By Yoda_Man

ive had really good luck using a self etching...

ive had really good luck using a self etching primer from a rattle can i use Proform PF654 then top coat with a nice gloss black. it looses its gloss after a year but doesnt wear off. even on...
Forum: General Boating Discussion
04-24-2014, 10:41 PM
Replies: 29
Views: 2,933
Posted By Yoda_Man

its been a few years around 6bucks a gallon. it...

its been a few years around 6bucks a gallon. it just means for me i plan my trips a bit more and make a weekend out of it rather than just an afternoon trip
Forum: Do It Yourself, Boating on a Budget
04-19-2014, 06:38 PM
Replies: 15
Views: 5,297
Posted By Yoda_Man

if you had a fire opening it fast could be the...

if you had a fire opening it fast could be the worst thing you could do adding all that air....... just somthing to think about
Forum: General Q & A
04-19-2014, 08:53 AM
Replies: 37
Views: 40,051
Posted By Yoda_Man

the only way i found my issue was swapping parts...

the only way i found my issue was swapping parts one by one from the other motor. was a msd coil now i carry a spare
Forum: General Q & A
04-17-2014, 01:30 PM
Replies: 37
Views: 40,051
Posted By Yoda_Man

I had a similar problem with one of my 502 mags...

I had a similar problem with one of my 502 mags turns out it was a bad coil still ran fine when not under load but when loaded up it had no power. no miss while running either. it had to have been...
Forum: General Boating Discussion
04-16-2014, 05:55 PM
Replies: 53
Views: 5,584
Posted By Yoda_Man

all the flakes that say they will buy it on the...

all the flakes that say they will buy it on the phone then never show up......
Forum: Members On-line Video Section!!
04-14-2014, 06:51 PM
Replies: 80
Views: 12,473
Posted By Yoda_Man

high impact u joints in offroading have gone away...

high impact u joints in offroading have gone away from using rollers in the caps instead they use a solid steel cross and a chromoly cap with a bronze liner. that works great for low speed but not...
Forum: Baja
04-10-2014, 07:58 AM
Replies: 17
Views: 1,931
Posted By Yoda_Man

the water came in during 1 trip coming back in...

the water came in during 1 trip coming back in some rough water every 15 or so min the nose would just catch the top of the wave and a slug of water would come over the dash onto the floor then drain...
Forum: Baja
04-09-2014, 08:53 PM
Replies: 17
Views: 1,931
Posted By Yoda_Man

it will make a bit of a mess but being able to...

it will make a bit of a mess but being able to get some lubricant on the end of the starter will be worth it
Forum: Baja
04-09-2014, 08:48 PM
Replies: 17
Views: 1,931
Posted By Yoda_Man

well, I had my small friend who was able to roll...

well, I had my small friend who was able to roll off the front of the engine and bend along the stringers to get to the starter without taking anything apart other than the raw water hose.

this is...
Forum: Baja
03-18-2014, 08:03 PM
Replies: 12
Views: 12,754
Posted By Yoda_Man

great link thanks

great link thanks
Forum: Baja
03-17-2014, 06:35 PM
Replies: 17
Views: 1,931
Posted By Yoda_Man

yep and about 3 years and 60 hours im a bit...

yep and about 3 years and 60 hours im a bit dissapointed
Forum: Baja
03-13-2014, 08:23 AM
Replies: 17
Views: 1,931
Posted By Yoda_Man

to me if it was a voltage problem it would...

to me if it was a voltage problem it would struggle to turn it over when engaged. but it doesnt
Forum: Baja
03-12-2014, 08:35 PM
Replies: 17
Views: 1,931
Posted By Yoda_Man

the starter in there spins but doesn't engage. ...

the starter in there spins but doesn't engage. after a few tries it will engage and turn it over with little effort. I don't want it to wreck my short season
Forum: Baja
03-11-2014, 06:20 PM
Replies: 17
Views: 1,931
Posted By Yoda_Man

changing port engine starter 322

so my 3 year old mercruiser starter has decided to give me troubles whats the best way to swap it? pull the engine? or pull the exhaust from both engines and hang upside down? the motors are...
Forum: General Boating Discussion
02-28-2014, 10:36 AM
Replies: 13
Views: 2,042
Posted By Yoda_Man

its too bad he didn't pretend to press start

its too bad he didn't pretend to press start
Forum: General Boating Discussion
01-16-2014, 09:04 PM
Replies: 24
Views: 14,301
Posted By Yoda_Man

ive got a blue sailrite and its great for...

ive got a blue sailrite and its great for working at home
Forum: General Q & A
01-10-2014, 04:23 PM
Replies: 11
Views: 1,723
Posted By Yoda_Man

the wife and I were coming back from Qualicum on...

the wife and I were coming back from Qualicum on Vancouver island heading towards the mouth of the Fraser river in some 6-8' waves fortunately we were going with the waves and the wind was dying down...
Forum: General Q & A
06-30-2013, 10:49 PM
Replies: 17
Views: 7,140
Posted By Yoda_Man

thanks guys for the good info

thanks guys for the good info
Showing results 1 to 25 of 100
 
Page 1 of 4
1
2
3
Last »


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.