Offshoreonly.com - Search Results

Search: Posts Made By: Lighting Bolt

Showing results 1 to 5 of 5
Search took 0.00 seconds.

Forum: Do It Yourself, Boating on a Budget

09-04-2012, 07:19 PM

Replies: 10

Carb tuning

Views: 1,713

Posted By Lighting Bolt

Plus I'm figuring it's been altered a good bit by...

Plus I'm figuring it's been altered a good bit by Nickerson performance since it was built for a blower and isn't boost referenced.

Forum: Do It Yourself, Boating on a Budget

09-04-2012, 07:17 PM

Replies: 10

Carb tuning

Views: 1,713

Posted By Lighting Bolt

I've tried settin them with up to .020 of the...

I've tried settin them with up to .020 of the slot showing past the blade to the blades being fully shut. I can even back the idle screws all the way off. I'm thinking the idle circuit is just way...

Forum: Do It Yourself, Boating on a Budget

09-02-2012, 09:20 PM

Replies: 10

Carb tuning

Views: 1,713

Posted By Lighting Bolt

Dist is locked out at 30deg. I've worked on the...

Dist is locked out at 30deg. I've worked on the idle screws every way possible with no luck on the idle surge. If you set the idle at a 1000rpm or higher it's smooth but going below 1000rpm it's...

Forum: Do It Yourself, Boating on a Budget

09-02-2012, 07:43 PM

Replies: 10

Carb tuning

Views: 1,713

Posted By Lighting Bolt

Also this is a 1050 dominator carb.

Also this is a 1050 dominator carb.

Forum: Do It Yourself, Boating on a Budget

09-02-2012, 01:59 PM

Replies: 10

Carb tuning

Views: 1,713

Posted By Lighting Bolt

Carb tuning

Ok boys I have a 477 BBC with cast iron rectangle port hi-performance gm heads. Pretty mild motor 4" stroke, 6.135 rods with flat top forged pistons. The compression ratio comes up to about 8.25:1 on...

Showing results 1 to 5 of 5