Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: Jonesyfxr
Showing results 1 to 6 of 6
Search took 0.01 seconds.
Forum: Do It Yourself, Boating on a Budget
01-16-2015, 05:36 AM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

Hey, that's why we're all here......to help each...

Hey, that's why we're all here......to help each other right??

Glad to see you found the problem. I think you'll have plenty more years of worry free boating from this day forward. Plus, there's...
Forum: Do It Yourself, Boating on a Budget
01-14-2015, 01:36 PM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

^^Definately a good, debateable point^^

^^Definately a good, debateable point^^
Forum: Do It Yourself, Boating on a Budget
01-14-2015, 11:00 AM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

I'd buy bare ring terminals, crimp them, solder...

I'd buy bare ring terminals, crimp them, solder them and then shrink wrap them. Then install with di-electric grease as previosly stated.
Forum: Do It Yourself, Boating on a Budget
01-13-2015, 09:37 AM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

I feel that it's a combination of old wiring and...

I feel that it's a combination of old wiring and corroded connections. I literally just rewired my whole boat. When I bought it, the gauge would read only 12 volts. After I was done it now reads...
Forum: Do It Yourself, Boating on a Budget
01-13-2015, 08:01 AM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

As stated you are experiencing a current draw...

As stated you are experiencing a current draw problem. If a radio voltage drops below say 11.5 volts they will shut down. This is similar to a problem my buddy had with a trim pump breaker. It...
Forum: Do It Yourself, Boating on a Budget
01-12-2015, 03:57 PM
Replies: 61
Views: 8,319
Posted By Jonesyfxr

I would check the wiring and grounds to the...

I would check the wiring and grounds to the actuator first, then move on from there.
Showing results 1 to 6 of 6


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.