Offshoreonly.com - Search Results
Offshoreonly.com

Go Back  Offshoreonly.com > Search Forums
Reload this Page >

Search Results

Register
FAQ
Calendar
Today's Posts
Search
Vendor Directory
Notices
Search: Posts Made By: blue thunder
Showing results 1 to 1 of 1
Search took 0.00 seconds.
Forum: General Q & A
01-17-2010, 12:45 PM
Replies: 4
Views: 1,656
Posted By blue thunder

A good general guideline is .001" clearance/inch...

A good general guideline is .001" clearance/inch of bore or shaft diameter as a min. Therefore, .0023 - .0025 on the rods, .0028 - .0032 on the mains. Up to .0035 on the rear main bearing. ...
Showing results 1 to 1 of 1


 
Forum Jump

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.